Delta 36-714 User Manual download pdf (Page 11)

BLADE TILTING AND RAISING

HANDWHEELS

Place blade tilting handwheel (A) Fig. 7A on shaft (B)

on the left side of the saw cabinet. Make certain slot

shaft. Place nylon washer (E) Fig. 7B on shaft then

thread locking knob (F) Fig. 7B, on shaft (G) and tighten

securely. Attach blade raising handwheel (H) Fig. 7B in

the same manner.

Fig. 7A

Fig. 7B

INSTALLING DRIVE BELT

First, lift motor and remove foam packing block from

around motor. While lifting motor (A) Fig. 8, place a 10-

12 inch long piece of 2x4, or another similar thickness

of wood, (B) Fig. 8 as shown. This will help prop up the

motor and will make it easier to install the grooved belt,

pulley located behind the motor (shown in Fig. 8B) and

the one directly above, located on the opposite end

of the blade arbor. Ensure that the grooves of the belt

completely make contact with the grooves in these

pulleys. Carefully lift motor and remove the block of

wood. The weight of the motor will provide the correct

tension on the belt. The belt (D) Fig. 8D is shown

installed correctly as seen through the open door in the

side of the saw.

Fig. 8D

Fig. 8

Fig. 8A

Fig. 8B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

No comments

Delta 36-714 User Manual Page 11