Delta 17-925 Instruction Manual download pdf (Page 7)

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

1. Assemble the column (A) Fig. 3, to the base (B) using

the four M10x40mm hex head screws (C), three of which

are shown. Loosen set screw (D) with 3mm wrench

supplied, and remove ring (E) and raising rack (F).

2. Insert small end of worm gear (G) Fig. 4 and Fig. 5,

through hole (H), from the inside of the table bracket.

Make certain that the worm gear engages the internal

gear in the table bracket.

3. Insert raising rack (F) Fig. 6, which was removed in

STEP 1, into groove in table bracket (I) making sure

teeth of internal gear, located inside table bracket, are

engaged with teeth of raising rack (F).

Fig. 3

Fig. 4

Fig. 5

Fig. 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Delta 17-925 Instruction Manual Page 7