Delta 28-195 Instruction Manual download pdf (Page 8)

ASSEMBLING

STAND AND FEET

1. Assemble the stand, as shown in Fig. 4, using the

32 M8x20mm Carriage head screws, 3/8" flat washers

and M8 hex nuts supplied. The two 10-3/4 long upper

braces (A); 13-9/16 long upper braces (B); 15-3/4 long

lower braces (C); and 18-5/16 long lower braces (D)

should be fastened to the four legs (E). Insert the

carriage bolts through the legs and braces, place flat

washer on carriage bolt and secure with nut.

IMPORTANT: The top lips of the two upper braces (A)

should be on top of the top lips of upper braces (B).

2. Assemble the four feet (F) Fig. 4, to bottom of each

leg (E), as shown.

ASSEMBLY INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE OWNER’S

MANUAL.

Fig. 4

Fig. 5

Fig. 6

ASSEMBLING

BAND SAW TO STAND

1. Place the band saw on top of the stand and line up

the four holes, located on the feet of the band saw, with

the four holes located on top of the stand.

2. Fasten the band saw to the stand using the four M8

x 35mm hex head bolts (A) Fig. 5, eight M8 flat washers

(B) and four M8 hex nuts (C), supplied. Place an M8 flat

washer on the hex head bolt and insert bolt through hole

on the band saw feet and hole in the stand. Place a flat

washer on the hex head bolt that has been inserted

through the saw and stand and secure with M8 hex nut.

3. Figure 6 illustrates the band saw assembled to the

stand.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

No comments

Delta 28-195 Instruction Manual Page 8