Delta 40-570 Instruction Manual download pdf (Page 11)

ADJUSTING HOLDDOWN

The holddown (A) Fig. 23, should be adjusted so it

contacts the top surface of the work (D) being cut by

loosening lock knob (B) and moving holddown rod (C)

up or down. Then tighten lock knob (B). The holddown

(A) Fig. 23, may be adjusted front to rear, by loosening

set screw (B) Fig. 24, and positioning the holddown in

the desired location. Once the holddown is in the

desired location, tighten set screw (B), Fig. 24.

ADJUSTING DUST BLOWER

The dust blower (A) Fig. 24, may be positioned to direct

air to the most effective point on the cutting line.

DUST COLLECTION CUP

A dust collection cup (A) Fig. 25 is provided and can be

attached to a shop vacuum system by utilizing the port

covered by cap (B).

INSIDE CUTTING

A blade threaded through a hole in the workpiece is

inside cutting. The Delta 16" Scroll Saw has the

capability of performing this operation quickly and

easily.

Loosen lock knob (A) Fig. 26, and raise the holddown

(B). Release blade tension by moving tension lever (C)

forward and loosen upper blade holder by moving lever

(D) to the rear as shown. This will release the blade (E).

Insert the blade (E) into the next hole in the pattern, as

shown.

Fig. 23

Fig. 24

Fig. 25

Fig. 26

Reassemble blade (E) Fig. 27, and tighten blade by

moving lever (D) forward (closed). Move tension lever

are ready to make the next inside cut.

Fig. 27

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Delta 40-570 Instruction Manual Page 11