Delta 40 Instruction Manual download pdf (Page 12)

Fig. 30

ADJUSTING

CLAMPING ACTION OF

UPPER BLADE HOLDER

Different widths of scroll saw blades will make it neces-

sary to adjust the clamping action of the upper blade

holder. It should be noted, however, that very little

adjustment is necessary and very little clamping force is

required to hold the blade satisfactorily.

1. Move the chuck locking lever (A) Fig. 30, to the rear

(open) position, as shown.

2. Turn locknut (C) Fig. 30, clockwise to tighten and

counterclockwise to loosen the clamping action of the,

blade holder. Very little movement of locknut (C) will be

necessary.

Fig. 31

Fig. 32

TILTING THE TABLE

The table on your scroll saw can be tilted 45 degrees to

the left for bevel cutting operations by loosening table

lock handle (A) Fig. 31, tilt the table to the desired angle

and tighten lock handle (A).

When bevel cutting, the holddown (B) Fig. 32, can be

adjusted to lay flat on the stock by loosening screw (C)

and tilting the holddown (B) accordingly. Then tighten

screw (C).

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Delta 40 Instruction Manual Page 12