Delta 40 Instruction Manual download pdf (Page 9)

ON-OFF AND VARIABLE

SPEED SWITCHES

Fig. 18

The on-off switch (A) Fig. 18, and variable speed switch

(B) is located on the left side of the scroll saw base, as

shown. To turn the saw "ON," push the top portion of

switch (A) and to turn the saw "OFF", push the bottom

portion of the switch (A).

This scroll saw is supplied with variable speeds of 400 to

1800 strokes per minute. When the variable speed

switch (B) Fig. 18, is rotated all the way to the left (coun-

terclock-wise) the speed will be 400 strokes per minute.

To increase the strokes per minute, rotate switch (B) to

the right (clock-wise) until the desired speed is obtained.

When the switch (B) is rotated all the way to the right

(clockwise) the speed will be 1800 strokes per minute.

LOCKING ON-OFF SWITCH

IN THE "OFF" POSITION

IMPORTANT: When the tool is not in use, the switch

should be locked in the off position using a padlock (C),

as shown in Fig. 19. This padlock is available as an an

accessory, Model 50-325 padlock.

Fig. 19

Fig. 20

Fig. 21

TABLE INSERT

The table insert (A) can be assembled to the saw table

with the opening in the insert pointing to the front of the

table, as shown in Fig. 20, or to the right as shown in Fig.

21.

With the table in the level position, 90 degrees to the

blade, the insert (A) should be positioned, as shown in

Fig. 20. This allows for the blade to be pivoted forward

after it is unclamped from the top blade holder, enabling

you to quickly insert the blade into the next hole in a pat-

tern when doing inside-cutting, as you will see later in

this manual.

When tilting the table for bevel cutting operations the

insert (A) should be positioned as shown in Fig. 21. This

allows for clearance of the blade when tilting the table.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 40 Instruction Manual Page 9