Delta Delta JT360 Instruction Manual download pdf (Page 20)

Fig. 50

Fig. 51

Fig. 52

Fig. 53

Fig. 54

ADJUSTING FENCE POSITIVE STOPS

The fence on this jointer is equipped with positive stops

that allow you to rapidly tilt the fence to the 90 and 45

degree angle to the table in the inward or outward

position. To check and adjust the positive stops, proceed

as follows:

1. Position the fence at 90 degrees to the table. Make

certain the end of plunger (A) Fig. 50, is engaged in notch

(B) in index collar as shown, and tighten lockhandle (C).

2. Place a square (D) Fig. 51, on the table and against

the fence and check if fence is 90 degrees to table.

3. If an adjustment is necessary, loosen set screw (E)

Fig. 50, in the index collar and loosen fence locking

handle (C).

4. Using the 90 degree edge of the square, tilt the fence

until you are certain the fence is 90 degrees to the table

and tighten lockhandle (C) Fig. 50, and set screw (E).

5. Loosen lockhandle (C) Fig. 52, pull out and turn

plunger (A) and tilt fence out as far as it will go. Then

tighten lock handle (C).

6. Using square (D) Fig. 52, check to see if the fence is at

a 45 degree outward angle from the table, as shown.

7. If an adjustment is necessary, loosen lockhandle (C)

Fig. 52. Loosen locknut (F) and turn adjusting screw (G)

until fence is tilted 45 degrees outward. Then tighten

locknut (F).

8. Loosen lockhandle (C) Fig. 53, and tilt fence inward as

far as possible, as shown, and tighten lockhandle (C).

9. Using a square (D) Fig. 53, check to see if the fence is

at a 45 degree inward angle to the table, as shown.

10. If an adjustment is necessary loosen locknut (J)

Fig. 54, and turn adjusting screw (H) until fence is tilted

45 degrees in. Then tighten lock nut (J).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

No comments

Delta Delta JT360 Instruction Manual Page 20