Delta MM300 Instruction Manual download pdf (Page 11)

Fig. 23

4. Push bit (A) Fig. 23, up through chisel and into

chuck (G) as far as it will go, and lock bit in chuck using

chuck key supplied.

Fig. 24

5. Loosen set screw (D) Fig. 24, and push chisel (B) up

against bottom of bushing (E), as shown, and tighten set

screw (D). This should provide the proper distance be-

tween the cutting lips of the bit and the points of the

chisel.

Fig. 25

PUSH

CHISEL UP

AGAINST

BUSHING

" to

CLEARANCE TO SUIT

TYPE OF WOOD

ADJUST BIT IN

CHUCK TO GIVE

CLEARANCE

6. The flat portion of the bit should be adjusted to a

minimum of 1/16" below the bottom of the chisel, as

shown in Fig. 25. For certain types of wood it may be

necessary to increase this distance up to a maximum of

3/16" clearance. This method assures having proper

clearance between the cutting edges of the bit and the

points of the chisel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Delta MM300 Instruction Manual Page 11