Delta MS450 Instruction Manual download pdf (Page 13)

Fig. 12

Fig. 13

ROTATING TABLE FOR MITER

CUTTING

1. The compound miter saw will cut any angle from a

straight 0° cut to 47° right and left. Turn locking knob

(A) Fig. 12 counterclockwise, depress lock lever (B),

and rotate table to desired position.

2. The compound miter saw is equipped with positive

stops at the 0° cut-off position and at the 22.5°,

31.62°, and 45° left and right positions.

3. The center line, (C) Fig. 13, on the cursor indicates

the actual angle of cut. Each scale line (B) represents

1°. In effect, when the center line (C) is moved from

one line to the next on the scale, the angle of the cut

is changed by 1°.

4. The pointer is provided with two additional lines (D)

and (E), Fig. 13. This allows movement of the control

arm exactly 1/2°. For example, assume the center

line (C) is pointing to the 10° mark on the scale, as

indicated, and and the angle of cut is 1/2° to the

right. Move the control arm until the right line (E) lines

up with the next line on the scale. The angle of cut

will then be changed 1/2° to the right. If you change

the angle of cut 1/2° to the left, use the left line (D) in

the same manner.

ADJUSTING SLIDING FIT BETWEEN

MOVABLE TABLE AND BASE

1. DISCONNECT THE MACHINE

FROM THE POWER SOURCE.

2. To adjust the sliding fit between the movable table

and the base, turn nut (A) Fig. 14, clockwise to

increase the sliding fit (opposite to decrease the fit).

This adjustment should not be so tight that it restricts

the rotating movement of the table, or so loose that

it affects the accuracy of the saw.

Fig. 14

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

No comments

Delta MS450 Instruction Manual Page 13