Delta PG-40 Specifications Page 52

  • Download
  • Add to my manuals
  • Print
  • Page
    / 179
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 51
5
VFD-B Series
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
5-17
Group 3: Output Function Parameters
03 - 00
Multi-function Output Terminal
(Relay contact point RA, RB, RC)
Factory Setting: 08
03 - 01
Multi-function Output Terminal MO1 Factory Setting: 01
03 - 02
Multi-function Output Terminal MO2 Factory Setting: 02
03 - 03
Multi-function Output Terminal MO3 Factory Setting: 20
Settings 00 to 28
Function Table List:
Setting Functions Descriptions
00 No function
01 AC Drive Operational
The terminal will be activated when there is
an output from the drive or RUN command is
“ON”.
02 Master Frequency Attained
The output will be activated when the AC
drive attains the Output Frequency Setting.
03 Zero speed
The output will be activated when Command
Frequency is lower than the Minimum Output
Frequency.
04 Over-Torque detection
The output will be activated as long as
over-torque is detected. (Refer to Pr.06-03 ~
Pr.06-05)
05 Baseblock (B.B.) Indication
The output will be activated when the output
of the AC drive is shut off by external
baseblock.
06 Low-Voltage Indication
The output will be activated when low voltage
is detected.
07 Operation Mode Indication
The output will be activated when operation
command is controlled by external terminal.
08 Fault Indication
The output will be activated when faults occur
(oc, ov, oH, oL, oL1, EF, cF3, HPF, ocA, ocd,
ocn, GFF).
09 Desired Frequency Attained 1
The output will be activated when the desired
frequency (Pr.03-04) is attained.
10 PLC Program Running
The Output will be activated when PLC
Program is running.
11 PLC Program Step Completed
The Output will be activated for 0.5 sec when
each multi-step speed is attained.
12 PLC Program Completed
The output will be activated for 0.5 sec when
the PLC program cycle has completed
Page view 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 178 179

Comments to this Manuals

No comments