Delta 36-978 Instruction Manual download pdf (Page 20)

10. Using a straight edge, check to see if the rear of

the splitter (G) is aligned with the saw blade, as

shown in Fig. 51. If alignment is necessary, loosen

the screws (B) Fig. 43, align splitter (G) with the saw

blade, and tighten two screws (B) Fig. 43.

11. Lower saw blade and install table insert (P) Fig. 52,

in the saw table as shown.

THE TABLE INSERT SHOULD BE LEVEL

WITH THE TABLE SURFACE. IF AN

ADJUSTMENT IS NECESSARY, SEE THE SECTION

“ADJUSTING TABLE INSERT”.

WHEN INSTALLING THE TABLE

INSERT, ALWAYS MAKE CERTAIN TO HOLD ON

TO THE BLADE GUARD (L). THE INSERT WILL

AUTOMATICALLY RELEASE THE HOLDING ACTION

ON THE SPLITTER AND LOWER THE BLADE GUARD

WHEN IT IS INSTALLED IN THE TABLE OPENING.

Fig. 51

Fig. 52

EXTENSION WINGS

1. Attach extension wing (A) Fig. 53, to the saw table.

Align the three holes in the extension wing with the

three holes in the side of the saw table.

FOR 36-978: Place a 7/16" Lockwasher (C) Fig. 53, then

a 7/16" Flat Washer (D) on a 7/16-20 x 3/4" Hex

Head Screw (B).

FOR 36-979: Place a 7/16" Lockwasher (C) Fig. 53, then

a 7/16" Flat Washer (D) on a 7/16-20 x 1¼" Hex

Head Screw (B).

2. Insert the screw through the hole in the extension

wing and thread the screw into the tapped hole in

the side of the saw table. Finger tighten only. Repeat

this process for the two remaining holes in the

extension wing and the saw table.

NOTE: MAKE SURE FRONT EDGE OF EXTENSION

WING IS FLUSH TO OR SLIGHTLY BEHIND THE

FRONT EDGE OF THE TABLE.

3. With a straight edge (E) Fig. 53, align the

extension wing (A) level with the saw table before

fully tightening the three screws (B). Starting with

the screw at the front, tighten the screw while

keepng the extension wings aligned with the table.

Then, move to the middle screw and follow the

same procedure of aligning and tightening. Then do

the same for the third screw.

MODEL 36-978 ONLY

4. Assemble the other sheet metal extension wing to

the opposite side of the saw table in the same manner.

MODEL 36-979 ONLY

4. Assemble the other cast iron extension wing to the

opposite side of the saw table in the same manner.

Fig. 53

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Comments to this Manuals

No comments

Delta 36-978 Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-978