Delta (Model 31-695) User Manual download pdf (Page 10)

Fig. 13

LOWER COVER FOR SANDING DISC

Use three M4.2 x 13mm pan head screws (C) to attach

the lower cover (A) Fig. 13 to the belt and pulley guard

(B).

Prevent the sanding disc from contacting

the lower cover. Rotate the sanding disc by

hand to ensure that no contact is made.

NOTE:

Fig. 14

Fig. 15

SANDER TABLE

1. Insert the support rod (A) Fig. 14 into the hole in the

side of the sander until the rod (A) extends

approximately 5-1/2". Align the flat on the rod (A)

with the screw (B). Tighten the screw with the hex

wrench (C).

2. Slide the table assembly (D) Fig. 15 on the rod (A).

Align the flat on the rod (A) with the set screws (E).

Tighten the screws to hold table assembly (D) in

position.

To avoid trapping the work or fingers

between sanding disc and table, the

table edge (F) Fig. 15 should be

positioned a maximum of 1/16" away

from sanding disc (G). Loosen screws

(E) and adjust table accordingly.

Fig. 16

STARTING AND STOPPING SANDER

The switch (A) Fig. 16 is located on the sander base. To

turn the sander “ON”, move the switch to the up

position. To turn the sander “OFF”, move the switch to

the down position.

OPERATING CONTROLS AND ADJUSTMENTS

5-1/2"

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Delta (Model 31-695) User Manual Page 10