Delta MS250 Instruction Manual download pdf (Page 14)

1. Loosen the bevel lock handle (A) Fig. 20 and move the cutting arm (B) Fig. 20 all the way to the right. Tighten the bevel lock

handle.

2. Place one end of a square (A) Fig. 27 on the table and the other end against the blade. Check to see if the blade is 90° to the

table (Fig. 27).

3. To adjust, loosen the locknut (B) Fig. 28, and turn the screw (C) until the head of the screw (C) contacts the casting (D) when

blade is 90° degrees to the table. Tighten the locknut (B).

If the fence (A) Fig. 24 is removed from the saw, adjust it after replacement so that it is 90° to the blade.

1. Place one end of the square (B) Fig. 24 against the fence (A) and the other end against the blade.

2. To adjust, loosen the four screws (C) Fig. 25, and adjust fence 90° degrees to the blade. Tighten the four screws (C).

1. You can limit the downward travel of the saw blade to

prevent it from contacting any metal surfaces of the

machine. Make this adjustment by loosening the locknut

(A) Fig. 26 and turning the adjusting screw (B) in or out.

2. Lower the blade as far as possible. Rotate the blade by

hand to make certain the teeth do not contact any metal

surfaces.

3. Tighten the locknut (A)

ADJUSTING THE FENCE 90° TO THE BLADE

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 24

Fig. 25

ADJUSTING THE DOWNWARD TRAVEL OF THE SAW BLADE

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 26

ADJUSTING 90° AND 45° BEVEL STOPS

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 27

Fig. 28

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

No comments

Delta MS250 Instruction Manual Page 14