Delta MS250 Instruction Manual download pdf (Page 15)

4. Loosen the bevel lock handle. Move the cutting arm all the

way to the left bevel position and tighten the bevel lock

handle.

5. Use a combination square (A) Fig. 29 to see if the blade is

at 45° to the table.

6. To adjust, loosen the locknut (E) Fig. 30, and turn the screw (F) until it contacts the casting (G). Tighten the locknut (E).

7. Check to see that the bevel pointer (P) Fig. 31 is pointing to the 45° mark on the bevel scale (S) Fig. 29. To adjust the bevel

pointer (P) Fig. 31, loosen the screw (H) and adjust pointer (P). Tighten the screw (H) securely.

8. These positive stops enable you to rapidly position the blade at the 90° and 45° bevel angle to the table.

Fig. 29

Fig. 30

Fig. 31

The tension of the cuttinghead return spring was adjusted

at the factory so that the cuttinghead returns to the "up"

position after cutting.

To adjust the spring tension, loosen the locknut (A) Fig.

32 and turn the screw (B) (clockwise to increase or

counterclockwise to decrease the spring tension). After

adjustment, tighten the locknut (A).

ADJUSTING THE TENSION OF THE CUTTINGHEAD RETURN SPRING

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 32

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

Delta MS250 Instruction Manual Page 15