Delta 20-330 Instruction Manual download pdf (Page 10)

ASSEMBLING STAND HANDLE

Insert ends of handle (A) Fig. 5, into the two holes (B) on

the right leg and fasten in place using the two cotter pins

supplied.

Fig. 5

ASSEMBLING STOCK ADVANCE STOP

Assemble the stock advance stop assembly (A) to the

hole on the front of the table and tighten the two set

screws (B), as shown in Fig. 6.

Fig. 6

ASSEMBLING GUARD AND BELT

Open the belt and pulley guard (A) Fig. 7, and position

the bottom half of the guard assembly behind the

pulleys (B) as shown. Line up the two holes in the

bottom of the guard with the two threaded holes in the

casting. NOTE: DO NOT COMPLETELY TIGHTEN THE

PULLEY GUARD TO THE CASTING AT THIS TIME.

Place a 1/4" flat washer onto a 1/4-20x1/2" hex head

screw and insert screw through hole in pulley guard and

thread screw into the tapped hole in the casting. Repeat

this process for the remaining hole. Raise the motor and

assemble the belt (D) Fig. 7, to the desired steps of the

two pulleys then release the motor. A speed selection

chart (E) is located on the inside of the guard cover.

When the belt is tensioned, tighten screws (C).

Fig. 7

FASTENING BAND SAW TO

SUPPORTING SURFACE

IF DURING OPERATION THERE IS ANY

TENDENCY FOR THE BAND SAW TO

TIP OVER, SLIDE OR WALK ON THE SUPPORTING

SURFACE, THE RIGHT LEG OF THE BAND SAW

MUST BE SECURED TO A SUPPORTING SURFACE.

Align the hole in the “L” shaped floor mounting bracket

(A) Fig. 8, with the hole in the bottom of the right leg (B).

Insert a 5/16” flat washer (C) onto a 5/16-18x1/2” hex

head screw (D). Insert screw through the floor mounting

bracket (A) and the right leg. Place a 5/16” flat washer

(E) onto the screw (D) and tighten securely. Repeat this

process for the remaining hole on the other side of the

right leg. Then secure the two brakcets to the supporting

surface.

Fig. 8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Delta 20-330 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Delta 20-330