Delta 28-280 Instruction Manual download pdf (Page 6)

Fig. 10

Fig. 11

Fig. 12

Fig. 13

5. Fasten the switch box to the band saw arm using two nuts

and lockwashers (A) Fig. 10, which were removed in STEP 3.

6. Remove screw and cable clamp (E) Fig. 11, from lower arm

of band saw.

7. Insert switch cord (F) Fig. 12, into clamp (E) which was

removed in STEP 6, and fasten switch cord (F) to band saw

as shown. IMPORTANT: CHECK AND MAKE CERTAIN THE

ON/OFF SWITCH-TO-MOTOR CORD (F) FIG. 7, IS NOT

CONTACTING MOTOR PULLEY OR BELT. ADJUST CORD

(F) FIG. 7, IF NECESSARY, THEN TIGHTEN CABLE TIE (H).

STARTING AND

STOPPING SAW

To start the saw, press the “START” button (K) Fig. 12. To stop

the saw, press the “STOP” button (L) Fig. 12.

LOCKING SWITCH IN

THE OFF POSITION

We suggest that when the saw is not in use, the switch be

locked in the “OFF” position using a padlock (M) Fig. 13,

through the switch plate and “START” button (K) as shown.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Delta 28-280 Instruction Manual Page 6