Delta 40 Instruction Manual download pdf (Page 10)

TILTING THE TABLE

The table (A) Fig. 20, on your scroll saw can be tilted up

to 45 degrees to the left for bevel cutting operations.

1. Turn the table insert 90 degrees to the right. NOTE:

ROTATE THE TABLE INSERT TO ALLOW YOU TO

TILT THE TABLE WITHOUT BENDING OR BREAKING

THE BLADE.

2. Loosen table lock handle (A) Fig. 20. Tilt table (B)

Fig. 20, to the desired angle and tighten lock handle (A).

NOTE: Table lock handle (A) Fig. 20, is spring-loaded

and can be repositioned by pulling outward on handle (A)

and repositioning hub of handle on the nut located un-

derneath the hub.

3. When bevel cutting, as shown in Fig. 21, the

holddown (C) can be adjusted to lay flat on the stock. If

the workpiece is too thick causing the stock to contact

the holddown arm (D), the complete holddown assembly

can be removed, since thick stock is heavy enough to

resist lifting off the table during the blade’s up stroke.

Fig. 20

Fig. 21

LEVELING THE TABLE

1. Using a square (A) Fig. 22, place one end of the

square on the table and the other end against the blade,

as shown. Check to see if the table is 90 degrees to the

blade.

2. If the table is not at 90 degrees to the blade, loosen

table lock handle (B) Fig. 23, and adjust the table until it

is 90 degrees to the blade. Then loosen screw (C) and

adjust pointer (D) until it points to the 0 degree mark on

the scale (E).

Fig. 22

Fig. 23

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Delta 40 Instruction Manual Page 10