Delta 40 Instruction Manual download pdf (Page 8)

WRENCH AND BLADE

STORAGE

A convenient wrench and blade holder (A) Fig. 13, is

supplied on the left side of the rear casting, which allows

you to store the quickset blade changing wrench (B) and

extra scroll saw blades when not in use.

Fig. 13

CHANGING BLADES

WARNING: THE USE OF ACCESSORIES OR AT-

TACHMENTS NOT RECOMMENDED BY DELTA MAY

RESULT IN RISK OF INJURY.

1. WARNING: TO AVOID INJURY FROM ACCIDEN-

TAL STARTING, ALWAYS TURN SWITCH “OFF” AND RE-

MOVE POWER CORD PLUG FROM ELECTRICAL OUT-

LET BEFORE REMOVING OR REPLACING BLADE.

2. Remove table insert.

3. Position blade tension lever (A) Fig. 19, in the vertical

position to release blade tension.

4. Insert long end (A) Fig. 14, of quickset blade

changing wrench into hole (B) in upper blade holder. This

will automatically align wrench (C) with blade holder

screw (D).

5. Fig. 15, illustrates the quickset blade changing

wrench (E) engaged with the upper blade holder

assembly. Turn wrench counterclockwise to loosen

screw (D) and remove blade (F) from upper blade holder

as shown.

Fig. 14

Fig. 15

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Delta 40 Instruction Manual Page 8