Delta 40 Instruction Manual download pdf (Page 6)

ASSEMBLY INSTRUCTIONS

WARNING: THE USE OF ACCESSORIES OR AT-

TACHMENTS NOT RECOMMENDED BY DELTA MAY

RESULT IN RISK OF INJURY.

WARNING: TO AVOID INJURY FROM ACCIDENTAL

STARTING, ALWAYS TURN SWITCH “OFF” AND RE-

MOVE POWER CORD FROM ELECTRICAL OUTLET

BEFORE REMOVING OR REPLACING BLADE.

1. Remove the blade from the upper blade holder. (See the

section “CHANGING BLADES”, begin with instruction #3).

2. Loosen lock handle (K) Fig. 5, and insert long end of

holddown assembly (D) up through hole in bracket (L).

Then tighten lock handle (K). Connect end of air hose (M)

to air nozzle (N) as shown.

3. Position table (B) Fig. 6, on the machine, as shown,

making sure pin (O) in rear table casting is engaged with

hole in base casting. Insert pivot bolt (E) through hole in

table casting (P) and thread bolt through threaded hole in

base casting (Q) using wrench (H) supplied. Thread M6

hex nut, supplied, on end of pivot bolt (E). Make sure the

tilt scale (R) is positioned inside pointer (S) as shown.

4. Position flat washers (J) Fig. 7, on inside and outside

of tilt scale (R) and thread end of table lock handle (I) into

hole (T).

5. Figure 8 illustrates table lock handle (I) assembled to

machine.

Fig. 5

Fig. 6

Fig. 7

Fig. 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Delta 40 Instruction Manual Page 6