Delta 43-290C Instruction Manual download pdf (Page 13)

Fence Controls and Adjustments

DISCONNECT TOOL FROM POWER SOURCE.

Figure 24

The fence halves (A) should be adjusted so that the opening

at the spindle is no more than is required to clear the cutter.

To adjust the fence halves, loosen indexable locking levers

(B) and slide fence halves to the required position. Tighten

locking levers.

Figure 25

Each fence half can be moved independently, forward or

backward, depending on the shaping operation. To move

the fence halves in or out, loosen one of the fence

adjustment allen screw (A). Turn one of the adjusting knobs

(B) to the correct setting. Tighten allen screw (A).

Each fence half can be adjusted for parallelism to the miter

gauge slot. If an adjustment must be made, loosen nuts

When parallelism is achieved, tighten nuts (C).

Fig. 24

Fig. 25

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Delta 43-290C Instruction Manual Page 13