Delta BS150LS Instruction Manual download pdf (Page 9)

3. Place a 3/8" flat washer (H) Fig. 7 on M8 x 45mm

hex head screw. Insert the screw through the hole in the

band saw and and through the hole in the stand. Repeat

this process for the three remaining holes.

Fig. 7

Fig. 8

4. Place a 3/8" flat washer on the screw (D) Fig. 8,

followed by M8 lock washer, then thread a M8 hex nut

on screw and tighten securely. Repeat this process for

the three remaining holes.

5. Push down on the top of the band saw, and make

sure that all four stand feet are contacting the

supporting surface. Tighten all stand har

dware.

ASSEMBLING TABLE TO

MACHINE

1. Remove table locking lever (A) Fig. 10 and table tilt

pinion knob (B). Be careful not to lose these parts.

(These components were assembled at the factory for

transit purposes only).

2. Remove the keeper screw, washer and wing nut from

the table slot (see Fig. 17 detail). Be careful not to lose

these parts.

3. Place table (H) Fig. 11 on the band saw frame so

that the keepers (K) protrude through the slot of the

trunnion (L).

Fig. 10

Fig. 11

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

No comments

Delta BS150LS Instruction Manual Page 9