Delta Delta JT360 Instruction Manual download pdf (Page 24)

24 - English

PLANING WARPED PIECES

If the wood to be planed is dished or warped, take light

cuts until the surface is flat. Avoid forcing such material

down against the table; excessive pressure will spring

it while passing the knives, and it will spring back and

remain curved after the cut is completed.

DIRECTION OF GRAIN

Avoid feeding work into the jointer against the grain

as shown in Fig. 72. The result will be chipped and

splintered edges. Feed with the grain as shown in Fig.

73, to obtain a smooth surface.

PLANING SHORT OR THIN WORK

When planing short or thin pieces, always use push

blocks to minimize all danger to the hands. Fig. 70,

illustrates using the Delta Push Blocks properly.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call

the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

Do not perform planning operations on

materials shorter than 10 inches (254 mm), narrower

than 3/4 inch (19 mm), wider than 6 inches (152.4 mm)

or less than 1/2 inch (12.7 mm) thick. See Fig. 71

Fig. 70

MINIMUM AND

MAXIMUM

PLANING

DIMENSIONS

1/2" (12.7 mm)

MINIMUM

3/4" (19mm) MINIMUM

6" (152.4 mm)

MAXIMUM

10" (254 mm) MINIMUM

Fig. 71

WRONG FEED - AGAINST THE GRAIN

IN-FEED TABLE

OUT-FEED

TABLE

CUTTER

Fig. 72

CORRECT FEED - WITH THE GRAIN

IN-FEED TA BLE

OUT-FEED

TABLE

CUTTER

Fig. 73

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

Comments to this Manuals

No comments

Delta Delta JT360 Instruction Manual Page 24

Comments to this Manuals

Related products and manuals for Power tools Delta Delta JT360