7
ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE DRILL PRESS TO THE POWER SOURCE
UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
2. Place the table (D) Fig. 5, on the drill press column
(A) as shown.
Fig. 5
1. Assemble the column (A) Fig. 4, to drill press base
(B) as shown, using the three M8x1.25x20mm hex head
cap screws (C).
Fig. 4
A
B
C
D
3. Thread stud on clamp handle (E) Fig. 6, into hole in
rear of table bracket as shown.
Fig. 6
E
Fig. 7
F
A
G
4. Place the drill press head (F) Fig. 7, onto the column
(A) as far as it will go. Align head (A) Fig. 7A, to table (B),
and base (C). Tighten the two head locking screws (G)
Fig. 7 with wrench supplied.
Fig. 7A
A
B
C
Comments to this Manuals