Delta TP305 Instruction Manual download pdf (Page 14)

8. Slide cutterhead guard (B) Fig. 25 in as far as

possible and replace two knobs, one of which is shown

at (A) Fig. 25. These knobs were removed in STEP 2.

Fig. 25

When using your machine, follow these few simple steps

for achieving the best results.

1. T

rue Up One Face

– Feed one face of the board

over a jointer, making thin cuts with each pass, until

the entire surface is flat.

2. Plane

to Thickness

– Place the side you planed in

STEP 1 face down and feed the board through the

planer, (Fig. 26). Plane until this side is flat, then

plane both sides of the board until you are satisfied

with the thickness. Make thin cuts, and alternate

sides with each pass. If, during the planing

operation, you notice the board twisting, warping, or

bowing, repeat STEP 1 and true up one face.

3. When planing long stock, provide table extensions

to support the infeed and outfeed end of the

workpiece.

4. Plane with the grain only, and keep planer table

clean. Occasionally, wax the table surface to reduce

friction during the planing operation.

5. Cr

oss-cut to

Final Length – Cross-cut lumber to final

length.

THE KNIVES ON THE PLANER WILL

NOT WEAR EVENLY IF THE WOOD IS

FED THROUGH THE SAME SPOT ON

THE TABLE EVERY TIME. FEED THE

WOOD THROUGH THE PLANER AT

DIFFERENT SPOTS ON THE TABLE

TO HELP ELIMINATE UNEVEN WEAR

OF THE KNIVES.

Fig. 26

MACHINE USE

MAINTENANCE

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.

NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

WEAR ANSI Z87.1 SAFETY GLASSES WHILE USING COMPRESSED AIR.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also,

check for blown fuses or open circuit breakers in the line.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call

the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

1 2 ... 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Delta TP305 Instruction Manual Page 14

Comments to this Manuals

Related products and manuals for Power tools Delta TP305