Delta TS300 Instruction Manual download pdf (Page 13)

1. Insert the handle (A) Fig. 19 into the threaded hole (B) in the rip fence (C).

2. Insert a flat-head screwdriver into the rip fence handle (A) Fig. 20 and tighten the screw.

3. Tighten the hex nut (D) Fig. 20 against the fence body.

RIP FENCE

Fig. 19

Fig. 20

LEVELING AND ADJUSTING THE FRONT GUIDE RAIL

DISCONNECT THE MACHINE FROM THE POWER SOURCE.

Fig. 21

Fig. 22

Fig. 23

Fig. 24

1. Turn the blade-raising handwheel (counter-clockwise)

to raise the saw blade to its maximum height.

2. With the handle (A) Fig. 21 in the raised position,

place the rip fence (B) on the saw table.

NOTE: Be certain that the rip fence (B) is engaged on

the rear guide rail (C). Move the rip fence (B) against

saw blade (Fig. 22).

3. Carefully move the front guide rail (D) Fig. 22 either

left or right until the line on the cursor (E) aligns with

the zero (“0”) on guide-rail scale (F). Push the handle

(A) down to lock the rip fence in position. Tighten the

front guide rail mounting hardware. You can make

minor adjustments to the cursor (E) Fig. 23 by loos-

ening the two screws (G), moving the cursor left or

right, then tightening the screws (G). Remove the rip

fence and lower the saw blade.

4. Use a square (H) Fig. 24 or a ruler to adjust the guide

rail (D) 13/16" from the top of the table along the

entire length of the rail.

5. Check to see that the rip fence is aligned with the

guide rail scale. Firmly tighten front guide rail

mounting hardware.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

No comments

Delta TS300 Instruction Manual Page 13