Delta MMC120 User Manual download pdf (Page 17)

MMC120 Linear Motion Control Module Setup Checklist

Delta Computer Systems, Inc. 360/254-8688 17

SETUP CHECKLIST

Wiring (Pages 18 and 19)

Wire magnetostrictive transducers to 9-pin terminal block on MMC120. See your transducer documentation

for connector pinout or cable color code information.

Wire MMC120 drive outputs (3-pin terminal block) to actuators (+out = axis extends)

Install and connect power supplies needed for your transducers

Installation (Page 18)

Define input and output registers

I/O Map the MMC120 (DCS MMC 120 0x, 4 input registers, 4 output registers)

Reserve memory for the module (parameters, profiles, event steps)

Start-up and Tuning

Run DCS120 setup program

Configure MMC120 to match transducers (See Configuration Word, bits 1-4onpage25)

Set Extend and Retract Limits

Tune the axes

Save parameters in DCS120 to a .BD1 file (S filename command - page 78)

Save parameters to Flash memory (page 43)

Read parameters and profiles into Programmable Controller

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 104 105

No comments

Delta MMC120 User Manual Page 17