Delta 32-326 Instruction Manual download pdf (Page 10)

Fig. 8 Fig. 9

Fig. 10

Fig. 11

TABLE TO MACHINE

1. Clip the two table slides (A) Fig. 8, to the table

bracket (B) as shown.

2. Clip the remaining two table slides to the other table

bracket in the same manner.

3. Center table (C) Fig. 9, on the machine frame as

shown.

4. Position table bracket (B) Fig. 10, against machine

frame (D) and underneath table (C) as shown, lining up

the two holes (E) Fig. 11, in the table with the two holes

(F) Fig. 10, on top of table bracket (B) Fig. 10.

5. Fasten the table to the table bracket using the two

1/4-20x1-1/4" flat head screws (E) Fig. 11, and two 1/4-

20 lock nuts (F) Fig. 10. NOTE: DO NOT TIGHTEN

HARDWARE AT THIS TIME.

6. Assemble the remaining table bracket to the other

side of the table and frame in the same manner.

Fig. 12

Fig. 13

7. Insert the 5/16-18x3/4" carriage bolt (G) Fig. 12, up

through square hole (H) and slot (J) as shown, and fasten

in place using the 5/16" flat washer (K) Fig. 13 and lock

knob (L). NOTE: DO NOT TIGHTEN HARDWARE AT

THIS TIME.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 10