Delta 32-326 Instruction Manual download pdf (Page 11)

Fig. 14

Fig. 15

FENCE TO MACHINE

1. Place spacer (A) Fig. 14, over hole (B) in table

bracket with large countersunk end of spacer (A) in the

up position.

2. Place a 1/4" lockwasher (C) Fig. 14, and a 1/4" flat

washer (D) on the 1/4-20x1-1/2" hex head screw (E) and

insert screw (E) up through hole (B) in table bracket and

through hole in spacer (A). Thread screw (E) into

threaded hole (F) on bottom of fence. NOTE: DO NOT

TIGHTEN HARDWARE AT THIS TIME.

3. Assemble remaining spacer to opposite end of fence

in the same manner.

4. Figure 15 illustrates the fence (G) assembled to the

table bracket. NOTE: DO NOT COMPLETELY TIGHTEN

THE TWO SCREWS, ONE OF WHICH IS SHOWN AT

(E), AT THIS TIME.

Fig. 16

Fig. 17

ALIGNING FENCE PARALLEL

TO LINE BORING HEAD

1. Set the right fence stop to 9 inches on the fence

scale and the left fence stop should be moved out

beyond the 9 inch mark. Position gage (A) Fig. 16, on

table as shown, with points of both indexing pins (B) over

holes (C) in gage.

2. Unscrew and remove knobs (D) Fig. 16, from top of

indexing pins.

3. Allow indexing pins (B) Fig. 17, to lower until points

of indexing pins engage the two holes in gage (A) as

shown.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 11