Delta 32-326 Instruction Manual download pdf (Page 14)

Fig. 28Fig. 27

4. Make certain air cylinder rod is retracted completely

into cylinder (E) Fig. 27. Loosen locknut (K) Fig. 27, and

unscrew hex end of clevis rod (L) until holes line up with

holes in bracket (N). Using retaining clip (A) and retaining

pin (B), which were removed in STEP 1, fasten clevis (L)

to bracket (N). Retighten locknut (K) Fig. 27. NOTE: It

may be necessary to loosen screws (R) Fig. 28, in order

to get pin to line up with clevis.

5. Insert black air supply line (S) Fig. 28, into top fitting

(G) of the air cylinder and blue air supply line (V) into

bottom fitting (H) of the air cylinder as shown. NOTE:

Push end of air lines as far as they will go into the

fittings.

Fig. 29

Fig. 30

Fig. 31

Fig. 32

ASSEMBLING TABLE

AIR CYLINDER CLAMPS

(For 32-326 Pneumatic Line Boring Machine

Only)

1. Assemble clamp bracket (A) Fig. 29, to bottom of

table using two 1/4-20x1-1/4" flat head screws (B) and

1/4-20 hex lock nuts (C).

2. Figure 30 illustrates one of the two clamp brackets

(A) assembled to the table with the two 1-1/4" long flat

head screws (B). Assemble remaining clamp bracket to

other end of table in the same manner.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 14