Delta 32-326 Instruction Manual download pdf (Page 12)

Fig. 18

Fig. 19

6. Loosen the two screws (E) Fig. 15, that fasten fence

(F) Fig. 19, to the machine and move fence (F) until front

surface of fence contacts gage at point (G) as shown, at

each end of the gage. Move the fence left or right until

the right fence stop, that was set in STEP 1, contacts the

gage at point (H). Then tighten the fence mounting

hardware. NOTE: FENCE STOP IS NOT SHOWN FOR

CLARITY.

7. Refer to the following instructions “ADJUSTING TA-

BLE PARALLEL TO FENCE.”

4. With index pins (B) Fig. 18, engaged with holes in

gage (A), loosen table lock knobs, one of which is shown

at (E), and move table until front end of fence (F) is

approximately 1/32" away from gage at point (G) on each

end of the gage. Then tighten the table lock knobs (E).

5. Using a small “C” clamp (not supplied), secure table

bracket (K) Fig. 18, to machine frame (L) at a point

between the two sides to avoid movement. Clamp the

other table bracket to the machine frame in the same

manner at the other side of the machine.

ADJUSTING TABLE

PARALLEL TO FENCE

1. Remove the gage (A) Fig. 18. The points of the index

pins (B) Fig. 18, should point to the 2-1/4" mark on both

scales.

2. If an adjustment is necessary, loosen four screws (C)

Fig. 20, that fasten the table to the machine frame and

adjust the table until index pins (B) point to the 2-1/4"

mark on scales (A). IMPORTANT: Make sure the table

mounting brackets are held securely against the machine

frame and tighten four screws (C).

3. Replace knobs (D) Fig. 21, to top of indexing pins (B)

as shown.

NOTE: The space between the rear of the table and the

front of the fence is for chip removal.

4. Remove two clamps temporarily assembled in STEP

of section “ALIGNING FENCE PARALLEL TO LINE BOR-

ING HEAD.”

Fig. 20

Fig. 21

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 12