Delta 32-326 Instruction Manual download pdf (Page 9)

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE

INSTRUCTION MANUAL.

ACCESSORY 32-331 STAND

If you purchased the accessory 32-331 steel stand for

use with your boring machine, assemble the stand as

shown in Fig. 6, using thirty-two 5/8" long carriage bolts,

flat washers and hex nuts. Align the holes in the legs with

the holes in the braces, insert a 5/16-18x5/8" carriage

bolt through the hole in the leg and the hole in the brace,

place a 5/16" flat washer onto the carriage bolt and

thread a 5/16-18 hex nut onto the carriage bolt and hand

tighten. Repeat this process for the thirty-one remaining

holes. NOTE: All braces mount to the inside of the legs.

NOTE: For ease in identifying and assembling the stand,

the two top front and rear braces (A) are 13-1/2" long; the

two top side braces (B) are 16-1/2" long; the two bottom

front and rear braces (C) are 19-1/2" long; and the two

bottom side braces (D) are 22-1/2" long. The four legs (E)

are 31-1/2" long. NOTE: Do not completely tighten the

stand mounting hardware until the machine is

assembled to the stand. Assemble the four plastic feet

(G) to the bottom of each leg (E) as shown.

Fig. 6

Fig. 7

MACHINE TO STAND

If you purchased the accessory 32-331 steel stand for

use with your boring machine, assemble the machine to

the stand using four 5/16-18x3/4" hex head screws, one

of which is shown at (A) Fig. 7, 5/16" flat washers, 5/16"

lockwashers and 5/16-18 hex nuts supplied with the

accessory stand. NOTE: Align the four holes in the

machine with the four holes in the stand. Insert the 3/4"

hex head screw through the top of the machine and

stand, place a flat washer onto the 3/4" hex head screw,

then place a lockwasher onto the 3/4" hex head screw,

and thread a nut onto the screw and tighten securely.

Repeat this process for the three remaining holes.

FASTENING MACHINE TO A SUPPORTING SURFACE

If you are using the boring machine without the accessory 32-331 steel stand, the machine MUST be fastened to a

supporting surface using suitable hardware, not supplied by Delta.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 32-326 Instruction Manual Page 9