Delta 36-325C Instruction Manual download pdf (Page 17)

ADJUSTING 90 AND 45 DEGREE POSITIVE STOPS

Your saw is equipped with positive stops that will position the saw blade at 90 and 45 degrees to the table. To check

and adjust the positive stops, proceed as follows:

1. DISCONNECT THE TOOL FROM THE POWER

SOURCE.

2. Turn the blade tilting handwheel clockwise as far as

it will go. Place a square (A) on the table and against the

blade, as shown in Fig. 36, and check to see if the blade

is at 90 degrees to the table. If the blade is not at 90

degrees to the table, loosen two set screws (B)

Fig. 37, back off collar (C) and turn the blade tilting

handwheel until the blade is at 90 degrees to the table.

Then adjust collar (C) Fig. 37, so that it contacts bracket

(D) when the blade is at 90 degrees to the table and

tighten the two set screws (B).

3. Turn the blade tilting handwheel counterclockwise as

far as it will go. Place a combination square (E) on the

table and against the blade, as shown in Fig. 38, and

check and see if the blade is at 45 degrees to the table.

If the blade is not at 45 degrees to the table, back off the

two locknuts (F) Fig. 37, and turn the blade tilting

handwheel until the blade is at 45 degrees to the table.

Then adjust the locknuts (F) Fig. 37, so that the inside nut

contacts bracket (D) when the blade is at 45 degrees to

the table. NOTE: After positive stops are set, check the

pointer position and adjust as necessary.

Fig. 36 Fig. 37

Fig. 38

Fig. 39

Fig. 40

ASSEMBLING RIP FENCE

TO GUIDE RAILS

To assemble the rip fence to the guide rails:

1. Make certain the lock handle (A) Fig. 39, of the rip

fence assembly (B) is in the up position.

2. Assemble the rip fence assembly (B) to both the

front and rear guide rails (C) as shown in Fig. 39.

3. Lock the rip fence (B) Fig. 40, on the guide rails (C)

by pushing down on lock handle (A).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Delta 36-325C Instruction Manual Page 17