Delta 36-960 Instruction Manual download pdf (Page 10)

2. Using template (D) Figures 27 and 28, to check and

adjust front rail at both ends of the saw t able as shown, to

make sure rail (A) is p arallel with t able surface and tighten

rail mounting hardware (B). IMPORTANT: Template (D)

must be on the saw table when checking, not on

extension wing.

3. Assemble rear rail (E) Fig. 29, to rear of saw t able

using the two

/8-24 x 1

/4″ hex head screws (F),

/8″ O.D.

flat washers, and lockwashers as shown. NOTE: When

mounting, the two screws (F) are threaded into the

threaded holes in the saw t able, as shown.

4. Make cert ain top edge of rail (E) Fig. 29 is below t able

surface and that top edge of cut-out s (G) are below miter

gage slot s before tightening screws (F).

ASSEMBLING TABLE LEGS

TO EXTENSION TABLE

1. Position the two legs (H) Fig. 30, at the two far corners

of the inside of one end of the extension t able, as shown,

and mark the position of the eight holes to be drilled into

the bottom of the t able. IMPORTANT: If your saw will be

used with a mobile base underneath the saw base and

table legs, the position of the legs may have to be

changed to fit onto the mobile base. Remove the two

legs (H) and using a

/16″ drill bit, drill the eight holes

/2″

deep. Replace the two legs and fasten to the bottom of the

table using the eight

/4″ wood screws (I) supplied.

2. Figure 31 illustrates one of the legs (H) fastened to

the bottom of the extension t able with the four wood

screws (I). Using a

/4″ drill bit, drill two through holes

through the end piece (J) of the t able, measuring the holes

from the out side frame of the t able. The holes are to be

drilled 1

/4″ from the top (laminate side), and 1

/8″ and 4

/8″

from the side.

Fig. 27

Fig. 28

Fig. 29

Fig. 30

Fig. 31

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Comments to this Manuals

No comments

Delta 36-960 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-960