Delta 36-960 Instruction Manual download pdf (Page 16)

to lock fence in position. NOTE: A magnet (B) Fig. 56, is

provided to hold clamp handle (A) in the up position when

moving the fence.

3. The dist ance the fence is positioned away from the

blade is indicated by the witness line (C) Fig. 57, located

on the cursor (D). If it is necessary to adjust the cursor (D),

make a test cut with the fence locked in position. Measure

the wid th of the finished cut and adjust the cursor (D) by

loosening the two screws (E), adjusting the cursor (D) until

the witness line (C) is aligned with the same marking on

the scale as the finished cut. Then tighten the two screws

(E).

FENCE LUBRICATION

1. Apply paste wax to fence, and guide tube, sliding sur -

faces weekly.

2. Apply grease to cam lock (A) and cam foot (B) Fig. 58,

monthly, to prevent wear.

ADJUSTING FENCE PARALLEL

TO MITER GAGE SLOTS

The fence (A) Fig. 59, must be adjusted so it is p arallel to

the miter gage slot s (B). To check and adjust, move fence

(A) until the bottom edge of the fence is in line with the

edge of one of the miter gage slot s as shown in Fig. 59,

and push down on the fence clamping lever (C). Check to

see if the fence (A) is p arallel to the miter gage slot, the

entire length of the t able. If an adjustment must be made,

lif t up fence locking lever (C) and raise fence up of f the

guide tube, as shown in Fig. 60. Slightly tighten or loosen

one of the two adjusting screws (D) or (E) Fig. 60, using a

/16″ alIen wrench (F), not supplied. Replace the fence on

the guide tube and check again to see if the edge of the

fence is p arallel with the miter gage slot the entire length

of the slot. Repeat this adjustment until you are sure the

fence is p arallel with the miter gage slot.

IMPORTANT: VERY LITTLE MOVEMENT OF

Fig. 57

Fig. 58

Fig. 59

Fig. 60

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

No comments

Delta 36-960 Instruction Manual Page 16