Delta 36-960 Instruction Manual download pdf (Page 13)

table board back onto the rear rail, and drill through the

holes in the rear rail through the t able board, Fig. 41.

7. Fasten the rear t able board to the rear rail with two 10-

32 screws, lockwashers, flat washers, and nut s, Fig. 42.

8. Level the t able by adjusting the t able legs in the rear

table board, Fig. 43.

FASTENING MOTOR CORD

TO SAW FRAME

1. IMPORTANT: Turn the blade tilting handwheel

counterclockwise as far as it will go until the saw blade is

in the 45 degree position.

2. IMPORTANT: Turn the blade raising and lowering

handwheel counterclockwise as far as it will go.

3. Fasten motor cord (A) Fig. 44 to the saw frame cross

member (B), using the cable tie (C) supplied with the saw.

CAUTION: Before tightening the cable tie, make cert ain

that cord (A) is free of any interference from the motor or

saw blade at all possible positions of the motor.

Af ter the cable tie is tightened, cut of f excess t ail of cable

tie (C) Fig. 44.

ASSEMBLING MOTOR COVER

1. Measure the three sides of the motor cover, (the sides

without the hinges), and cut gasket to fit each side.

Remove the protective paper from the gasket material

supplied with the machine and apply gasket (A) Fig. 45, to

three sides of the back of the motor cover (B). NOTE: Do

not apply gasket to the hinged side (C) of the motor cover

(B) Fig. 45.

2. Assemble hinged side (C) Fig. 46, of motor cover (B)

Fig. 42

Fig. 43

Fig. 44

Fig. 45

Fig. 46

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

No comments

Delta 36-960 Instruction Manual Page 13