Delta 36-960 Instruction Manual download pdf (Page 20)

11. Loosen locknut (C), and turn adjusting screw (D)

counter clockwise, on turn.

12. T urn the blade tilting handwheel until the blade is 45

degrees to the t able.

13. T urn adjusting head screw (D) clockwise, until it just

cont act s the casting on the front trunnion, then tighten

locknut (C), until it is locked into place.

14. Check to see if the tilt indicator pointer point s to the 45

degree mark on the scale. Adjust if necessary

ADJUSTING TABLE

The saw table has been aligned at the factory so the miter

gage slot s are p arallel to the saw blade; however, it is

recommended to check the alignment before initial

operation as follows:

1. DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

2. Place a combination square (A) Fig. 70, on the t able

with one edge of the square in the miter gage slot, as

shown, and adjust the square so the rule just touches one

of the teeth on the saw blade at the forward position, as

shown in Fig. 70. Lock the square in this position.

3. Rotate the saw blade so that the same tooth you used

in STEP 2 is in the rear position, as shown in Fig. 71, and

check this dist ance. Both the front and rear measurements

should be identical.

4. If an adjustment is necessary, loosen the four screws

that hold the t able to the saw cabinet.

5. Shif t the t able until a position is found which brings the

saw blade in the center of the t able insert slot, and p arallel

to the miter gage slot.

6. Tighten the four screws that were loosened in STEP 4.

MITER GAGE OPERATION

AND ADJUSTMENT

Insert the miter gage bar into the miter gage slot and

assemble the washer and lock handle (A) Fig. 72, to the

miter gage bar as shown.

The miter gage is equipped with adjust able index stop s at

90 degrees and 45 degrees right and left. Adjustment to

the index stop s can be made by tightening or loosening

the three adjusting screws (B) Fig. 73.

To rot ate the miter gage, loosen lock knob (A) Fig. 73, and

move the body of the miter gage (C), to the desired angle.

Fig. 70

Fig. 71

Fig. 72

Fig. 73

Fig. 74

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

Delta 36-960 Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-960