12
3
/4″ wood screws (I) supplied.
2. Figure 37 illustrates one of the legs (H) fastened to the
bottom of the extension t able with the four wood screws
(I). Using a
1
/4″ drill bit, drill two through holes through the
end piece (J) of the t able, measuring the holes from the
out side frame of the t able. The holes are to be drilled
3
/4″
from the bottom, and 1
1
/4″ and 4
1
/4″ from the side.
3. Fasten the leg bracket (L) Fig. 38, to the end piece (J)
of the t able using the two 1
1
/2″ flat head Phillip s screws,
flat washers and hex nut s (M) Figs. 37 and 38. Fasten the
remaining leg to the extension t able in the same manner.
4. Position the t able onto the rear rail, making sure there
is clearance for the miter gage slot s and blade guard, and
mark the spots to be drilled in the rear rail to att ach the
rear support t able. NOTE: DRILL THE HOLES
1
/4
″″
FROM
THE EDGE OF THE RAIL, AND 7
1
/2
″″
FROM EACH
EDGE OF THE REAR TABLE SO THAT THERE WILL
BE PROPER CLEARANCE FOR ATTACHING THE
HARDWARE.
5. Use a
3
/16″ drill bit to drill the two holes in the rear rail,
approximately 7
1
/2″ from each corner of the t able board,
Fig. 39 & 40.
6.Af ter the holes are drilled in the rear rail, position the
Fig. 39
Fig. 40
Fig. 41
Fig. 37
M
I
J
H
Fig. 38
J
L
M
Comments to this Manuals