Delta ShopMaster A05581 Instruction Manual download pdf (Page 16)

MITER GAGE HOLDER

DISCONNECT MACHINE FROM

POWER SOURCE.

1. Assemble spring clip (E) Fig. 26, to the miter gage

holder (A) as shown using a M4x.7x10mm pan head

screw (F), 3/16" lockwasher and M4x.7 hex nut. NOTE:

Hex nut (G) Fig. 27, will fit into the recess at the back of

the miter gage holder (A) to keep spring clip (E) Fig. 26,

secured to the miter gage holder.

2. Assemble the miter gage holder (A) Fig. 28, to the left

side of the saw cabinet using the four M4.2x10mm pan

head screws (B) Fig. 29, and 3/16" washers (C) from

inside saw cabinet.

3. Fig. 30, illustrates the miter gage (D) inserted into the

miter gage holder when not in use.

Fig. 29

Fig. 26

Fig. 27

Fig. 28

Fig. 30

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

No comments

Delta ShopMaster A05581 Instruction Manual Page 16