Delta 36-235 Specifications download pdf (Page 11)

CONNECTING S AW TO POWERSOURCE

POWERCONNECTIONS

A sep arate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and

should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension

cords which have 3-prong grounding type plugs and 3-pole recept acles which accept the tool s plug.

Before connecting the motor to the power line, make sure the switch is in the OFF position and be sure

that the electric current is of the same characteristics as indicated on the tool. All line connections should

make good contact. Running on low volt age will damage the motor.

M O TO R SPECIFICATIONS

Y our saw is wired for 110-120 volt s, 60 HZ alternating current. Before connecting the saw to the power

source, make sure the switch is in the OFF position. The motor provides a no-load speed of 3600 RPM.

GROUNDING INSTRUCTIONS

CAUTION: THIS TO O L MUST BE GROUNDED WHILE IN USE

TO PROTECT THE OPERATO R FROMELECTRIC SHOCK.

Fig. 13 Fig. 14

GROUNDED OUTLET BOX

CURRENT

CARRYING

PRONGS

GROUNDING BLADE

IS LONGEST O F THE 3 BLADES

GROUNDED OUTLET BOX

GROUNDING MEANS

ADAPTER

CAUTION: IN ALL CASES, MAKE CERTAIN THE RE-

CEPTACLE IN QUESTION IS PROPERLY GROUNDED.

IF Y O U A R E N O T SURE, H AVE A CERTIFIED ELEC-

TRICIAN CHECK THERECEPTACLE.

This tool is intended for use on a circuit that has an outlet

and a plug that looks like the one shown in Fig. 13. A

temporary adapter, which looks like the adapter illustrated

in Fig. 14, may be used to connect this plug to a 2-pole

recept acle, as shown in Fig. 14, if a properly grounded

outlet is not available. The temporary adapter should be

used only until a properly grounded outlet can be in-

st alled by a qualified electrician. THIS ADAPTER IS

N O T APPLICABLE IN CANADA. The green-colored

rigid ear , lug, and the like, extending from the adapter

must be connected to a permanent ground, such as a

properly grounded outlet box, as shown in Fig. 14.

In the event of a malfunction or breakdown, grounding

provides a p ath of least resist ance for electric

current to reduce the risk of electric shock. The motor is

equipped with an electric cord having an equipment-

grounding conductor and a grounding plug. The plug

must be plugged into a matching outlet that is properly

inst alled and grounded in accordance with all local codes

and ordinances.

Do not modify the plug provided - if it will not fit the outlet,

have the proper outlet inst alled by a qualified electrician.

Improper connection of the equipment-grounding conduc -

tor can result in risk of electric shock. The conductor with

insulation having an outer surface that is green with or

without yellow stripes is the equipment-grounding conduc -

tor. If rep air or replacement of the electric cord or plug is

necessary, do not connect the equipment grounding con -

ductor to a live terminal.

Check with a qualified electrician or service personnel if

the grounding instructions are not completely under -

stood, or if in doubt as to whether the tool is properly

grounded.

Use only 3-wire extension cords that have 3-prong

grounding type plugs and 3-hole recept acles that accept

the tool s plug, as shown in Fig. 13.

R e p air or replace damaged or worn cord immediately.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Delta 36-235 Specifications Page 11

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-235