Delta 36-235 Specifications download pdf (Page 18)

Fig. 30

Fig. 31

Fig. 32

Fig. 33

ADJUSTING

90 AND 45 DEGREE BEVEL

POSITIVE STO P S

1. DISCONNECT THE S AW FROM THE POWER

SOURCE.

2. Loosen bevel lock handle and move the cuttinghead

all the way to the right. Then tighten bevel lock handle

and lock cuttinghead in the down position.

3. Using a square (A) Fig. 30, place one end of the

square on the t able and the other end against the blade,

as shown. Check to see if the blade is at 90 degrees to

the t able.

4. If an adjustment is necessary, loosen bevel lock

handle (H) Fig. 31. Then loosen locknut (B) and turn

adjusting screw (C), with wrenches provided, until blade

is 90 degrees to the t able. Then tighten locknut (B) and

bevel lock handle (H).

5. When you are cert ain blade is 90 degrees to t able,

adjust pointer to line up with the 0 degree mark on bevel

scale.

6. Loosen bevel lock handle and move cuttinghead all

the way to the lef t bevel position and tighten bevel lock

handle.

7. Using a square (A) Fig. 32, check to see if the blade

is at 45 degrees to the t able, as shown.

8. If an adjustment is necessary, loosen bevel lock

handle. Then loosen locknut (E) Fig. 33, and turn adjust -

ing screw (F), with wrenches provided, until blade is 45

degrees to the t able. Then tighten locknut (E) and bevel

lock handle.

9. These positive stop s enable you to rapidly position

the blade at the most common bevel angles to the t able,

90 and 45 degrees.

C B

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Delta 36-235 Specifications Page 18