Delta 36-235 Specifications download pdf (Page 9)

Fig. 7J

Fig. 8

Fig. 9

Fig. 10

9. Position lock handle (M) Fig. 7J, on locking stud and

replace screw and spring (L) that were removed in STEP 7.

NOTE: Lock handle (M) is spring-loaded and can be re-

positioned by lif ting up on handle and repositioning it on

stud located underneath handle.

ASSEMBLING WORK CLAMP

1. The st andard equipment work clamp can be assembled

to any one of the three holes (A) Fig. 8, provided on the

base of the machine, as follows:

2. Thread lock knob (B) Fig. 9, into threaded hole on

side of hole to be used and insert post (C) of work clamp

down through hole as far as possible. Then tighten lock

knob (B). An additional lock knob (B) is supplied and can

be threaded into one of the other three holes. W e suggest

having the two lock knobs, one of which is shown at (B),

threaded into the two most commonly used holes where

the work clamp will be used.

3. For proper operation and adjustment of the work

clamp, refer to section WORKCLAMP OPERATION .

ASSEMBLING DUST BAG

1. Depress spring clip s (A) Fig. 10, of dust bag (B) and clip

dust bag (B) onto end of dust chute, as shown.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 36-235 Specifications Page 9