Delta 36-235 Specifications download pdf (Page 24)

Fig. 47Fig. 46

1. When cutting flat pieces, first check to see if the

material is bowed. If it is, make sure the material is posi -

tioned on the t able as shown in Fig. 46.

2. If the material is positioned the wrong way, as shown

in Fig. 47, the workpiece will pinch the blade near the

completion of the cut.

CONSTRUCTING WORK SUPPORT EXTENSIONS

One of the unique features of your miter saw is the ease with which you can construct work support s. Fig. 48,

illustrates the miter saw mounted to two st andard 2 x 4 s (A). Fasten the grooves in the two mounting legs (B), to

the 2 x 4 s using four screws through the four holes in the mounting legs. The length of the 2 x 4 s (A) can vary

depending on your preference. The dist ance from the top of the 2 x 4 s (A) to the compound miter saw t able is

3-5/8 inches. This enables you to fasten st andard 2 x 4 s (C) to the top of the 2 x 4 s (A), as shown. The top of the

2 x 4 s (C) will then be the same height as the miter saw t able; or minor adjustment s can easily be made depend -

ing on the height of your 2 x 4 s. This method allows you to provide support for long workpieces using st andard

2 x 4 s instead of constructing an expensive, complicated work support.

CUTTING BOWED MATERIAL

Fig. 48

RIGHT WRONG

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

Delta 36-235 Specifications Page 24