Delta 36-235 Specifications download pdf (Page 15)

Fig. 23

Fig. 24

Fig. 25

Fig. 26

TABLE HAZARD AREA

W ARNING: THE AREA INSIDE T H E T W O R E D LINES

(A) FIG. 23, ON T H E TABLE IS DESIGNATED A S A HAZ-

ARD

ZONE. NEVER PLACE YOURHANDS INSIDE THIS

AREA

WHILE THE TO O L IS BEING OPERATED.

WORK CLAMP OPERATION

1. The height of the work clamp (A) Fig. 24, can be

adjusted by loosening lock knob (B) and moving post (C)

up or down, or depressing lock lever (D) and sliding clamp

body (E) up or down. Af ter height of clamp (A) is adjusted,

tighten lock knob (B) and/or release lock lever (D).

2. During operation, lower clamp (A) Fig. 25, by de-

pressing lock lever (D), until the bottom of the clamp (A)

lightly cont act s top of workpiece (F). IMPORTANT:

When lowering clamp (A) make certain cam lever (G)

is in the up position as shown.

3. For final clamping of the workpiece (F) Fig. 26,

against the t able, move cam lever (G) to the rear , as

shown. Af ter cut is completed, lif t lever (G). This will raise

clamp (A) slightly , allowing you to slide or remove work -

piece (F).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Delta 36-235 Specifications Page 15