Delta SA180 Operations Instructions download pdf (Page 10)

Fig. 5

Fig. 6

Fig. 7

Fig. 8

ASSEMBLING GUARD FOR SANDING DISC

AND BELT AND PULLEYS

1. Disconnect machine from power

source.

2. Position the guard (A) Fig. 5, in place on the disc

unit frame and fasten in place using the two

M4x.07x10mm cheese head screws (B) and (C) and

two 3/16" flat washers. DO NOT COMPLETELY

TIGHTEN SCREWS (B) AND (C) AT THIS TIME AS

THE GUARD MUST BE ADJUSTED TO SANDING

DISC PLATE. NOTE: Access to screw (C) is

through hole (D) in top of guard.

3. Assemble the inside guard (E) Fig. 6, to the guard

assembly using a M4x.07x45mm cheese head

screw (F) Fig. 7, and M4x.07 wing nut (G) Fig. 6, as

shown.

ASSEMBLING SANDING DISC TO DISC

PLATE

1. Make sure the disc plate (A) Fig. 8, is clean.

2. Peel backing from sanding disc and press the

sanding disc (B) firmly onto the disc plate (A), as

shown in Fig. 8.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Delta SA180 Operations Instructions Page 10