Delta SA180 Operations Instructions download pdf (Page 15)

Fig. 27

The table can be tilted 45 degrees to the front, as shown

in Fig. 27, by loosening lock lever (B). Use a combination

square (E) check to set the table at 45 degrees to the belt

and tighten lock lever (B).

To avoid trapping the work or fingers

between the table and sanding belt, the table edge

sanding belt (D) when the table is tilted.

DISC TABLE ADJUSTMENTS

The disc table (A) Fig. 28, can be tilted 45 degrees up or

down, by loosening lock handle (B), tilting the table, and

tightening lock handle (B). NOTE: The lock handle (B) is

spring-loaded and can be repositioned by pulling out the

handle (B) and repositioning it on the serrated locking

stud located directly underneath the handle.

To avoid trapping the work or fingers

between the table and sanding disc, the sanding disc

from edge of table (D).

This can be accomplished by moving the sanding disc in

or out on the motor shaft.

To check and see if the table is at 90 degrees to the

sanding disc, place a square (E) Fig. 29, on the table

with one end of the square against the sanding disc, as

shown. If an adjustment is necessary, loosen lock lever

(B), move table until you are certain it is at 90 degrees to

the sanding disc and tighten lock lever (B).

Then loosen screw (F) Fig. 30, and adjust pointer (G) so it

points to the "0" degree mark on the table scale.

Fig. 28

Fig. 29

Fig. 30

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

No comments

Delta SA180 Operations Instructions Page 15