Delta SA180 Operations Instructions download pdf (Page 11)

Fig. 9

Fig. 10

Fig. 11

Fig. 12

ASSEMBLING SANDING DISC PLATE TO

MOTOR SHAFT

1. Disconnect machine from power

source.

2. Assemble the sanding disc plate (A) Fig. 9, to the

motor shaft with the key (B) in the motor shaft,

engaged with the keyway (C) in the hub of the

sanding disc.

3. Rotate the sanding disc until the set screw (D) Fig. 9,

is in the up position. Insert the 2.5mm wrench (E) Fig.

10, through hole (F) Fig. 10, and tighten sanding disc

set screw (D) Fig. 9.

4. Adjust the disc guard so that the lip (G) Fig. 10,

covers the outer edge of the sanding disc, but

not past the face of the disc, and tighten the two

M4x.07x10mm cheese head screws, one of which is

shown at (H), that attach the disc guard to the base.

ASSEMBLING LOWER SANDING DISC

GUARD

1. Disconnect machine from power

source.

2. Assemble the lower sanding disc guard (A) to the

disc base using the three M4x.07x10mm cheese

head screws (B), as shown in Fig. 11.

ASSEMBLING SANDING DISC DUST CHUTE

Assemble the sanding disc dust chute (A) to the disc

sander base using the M6x1x15mm cheese head screw

and 6.4mm internal tooth lockwasher (B), as shown in

Fig. 12.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

No comments

Delta SA180 Operations Instructions Page 11