Delta 36-040 Instruction Manual download pdf (Page 12)

MAINTENANCE

CHANGING THE BLADE

WARNING: USE ONLY CROSS-CUTTING SAW

BLADES. WHEN USING CARBIDE TIPPED BLADES,

DO NOT USE BLADES WITH DEEP GULLETS AS THEY

CAN DEFLECT AND CONTACT GUARD. USE ONLY

8-1/4" DIAMETER SAW BLADES RATED FOR 6000

RPM OR HIGHER WITH 5/8" ARBOR HOLES.

1. DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

2. Loosen screws (B) and (C) Fig. 28, and rotate lower

blade guard assembly to the up position.

3. Press in on arbor lock (D) Fig. 29, to keep the arbor

from turning, and unscrew and remove arbor screw (E).

NOTE: Turn arbor screw (E) clockwise to remove.

4. Remove outside blade flange (F) Fig. 30, and saw

blade (G).

5. To install new blade make sure inside blade flange (H)

Fig. 31, is completely on arbor with the flats in the flange

engaged with the flats on the arbor.

6. Install new blade (J) Fig. 32, outside blade flange (F)

and arbor screw (E). Turn arbor screw counterclockwise

to tighten while pressing in on arbor lock to keep the

arbor from turning. IMPORTANT: Make sure flats in out-

side blade flange are engaged with flats on arbor shaft

and that teeth of saw blade are pointing down at the

front, as shown in Fig. 30.

Fig. 30

Fig. 29

Fig. 28

Fig. 32

Fig. 31

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta 36-040 Instruction Manual Page 12