Delta 36-220 Instruction Manual download pdf (Page 17)

Fig. 37 Fig. 38

Fig. 39

When performing multiple or repetitive cut-off operations

that result in small cut-off pieces, one inch or less, it is

possible for the saw blade to catch the cut-off pieces and

project them out of the machine or into the blade guard

and housing, possibly causing damage or injury. In order

to limit the possibility of personal injury or blade guard

damage, an auxiliary wood fence can be mounted to your

saw as follows:

Holes are provided in the fence to attach an auxiliary

fence (A) Fig. 39. This auxiliary fence is constructed of

straight wood approximately 1/2 inch thick by 3 inches

high by

20 inches long. NOTE: The auxiliary fence (A) is used

ONLY with the saw blade in the 0 degree bevel position

(90 degrees to the table). When bevel cutting (blade tilt-

ed) the auxiliary fence will have to be removed.

AUXILIARY WOOD FENCE

1. Move the table to the 31-5/8 degree right miter position and lock the table in position. NOTE:

A triangle indicator is provided on the miter scale to find this angle quickly.

2. Tilt the saw blade to the 33-7/8 degree left bevel position and tighten bevel lock handle. NOTE:

A triangle indicator is provided on the bevel scale to find this angle quickly.

3. Place the crown moulding on the table with the CEILING EDGE of the moulding against the

fence, and make the cut, as shown in Fig. 37. NOTE: The piece of crown moulding used for the

outside corner will always be on the right hand side of the blade, as shown at (A) Fig. 37. The piece

of crown moulding used for the inside corner will always be on the left hand side of the blade, as

shown at (B) Fig. 37.

4. To make the matching halves of the inside and outside corners simply rotate the table to the

31-5/8 degree left miter position and tighten table lock knob. NOTE: A triangle indicator is provid-

ed on the miter scale to find this angle quickly.

5. Place the crown moulding on the table with the WALL EDGE of the crown moulding against

the fence and make the cut. Again, the piece of crown moulding used for the outside corner will

always be on the right side of the blade, as shown at (C) Fig. 38. The piece of crown moulding

used for the inside corner will always be on the left side of the blade, as shown at (D) Fig. 38.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Delta 36-220 Instruction Manual Page 17