Delta 36-979 Instruction Manual download pdf (Page 9)

CUTTERHEAD GUARD

1. Attach the cutterhead guard (A) Fig. 7 to the planer

by inserting the end of the guard over the top of the

cutterhead. Place the slots in the cutterhead guard (C)

over the tapped holes (B).

2. Fasten cutterhead guard (A) Fig. 8 to planer using two

knobs, one of which is shown at (D).

Make sure that the cutterhead guard is

properly secured with the knobs before operating this

machine.

FASTENING PLANER TO SUPPORTING

SURFACE

During operation, if there is any tendency for the planer to

tip over, slide or "walk" across the supporting surface, the

planer must be secured to the supporting surface. Four

holes (two of which are shown at (A) Fig. 9 are provided

for this purpose.

Fig. 8

Fig. 7

Fig. 9

OPERATION

STARTING AND STOPPING PLANER

Make sure that the switch is in the

"OFF" position before plugging cord into outlet. Do

not touch the plug’s metal prongs when unplugging or

plugging in the cord.

1. The on/off switch (A) Fig. 10 is located on the front

of the planer moter. To turn the machine "ON", move

the switch up to the "ON" position.

2. To turn the machine "OFF", move the switch (A) down

to the "OFF" position.

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta 36-979 Instruction Manual Page 9