Delta BS220LS Instruction Manual download pdf (Page 8)

3. Place a M8.4 flat washer onto a M8x1.25x45mm hex

head screw. Insert the screw through the hole (D) Fig. 6,

in the stand and thread screw into the tapped hole in the

band saw and tighten securely. Repeat this process for

the remaining hole in stand and threaded hole in the

band saw and tighten securely.

Fig. 6

Fig. 7

4. Align the remaining two holes (A) Fig. 4, with the two

holes in the stand. Place a M8.4 flat washer (H) Fig. 7, on

a M8x1.25x45mm hex head screw. Insert screw (F)

through the hole in band saw and the hole in the stand.

Place a M8.4 flat washer onto screw (F) Fig. 7, and

thread a M8x1.25 hex nut onto screw (F) and tighten

securely.

5. Place a M8.4 flat washer onto a M8x1.25x45mm hex

head screw. Insert screw (G) Fig. 7, through the hole in

stand and the hole in the band saw. Place a M8.4 flat

washer onto screw (G) Fig. 7, and thread a M8x1.25 hex

nut onto screw (G) and tighten securely.

6. Push down on the top of the band saw, and make

sure that all four stand feet are contacting the

supporting surface. Tighten all stand hardware at this

time.

TABLE

1. Remove the M6x1x30mm cheese head screw (A),

M6.4 flat washer (B), and M6x1wing nut (C) Fig. 8, from

slotted end (D). Slide table (E) into position on the band

saw as shown in Fig. 8.

Fig. 8

2. Align the three holes in the table bracket (F) Fig. 9,

with the three holes in the side of the band saw. Place a

M8.4 flat washer onto a M8x1.25x70mm. Insert the

screw through the hole (G) Fig. 9, in the table bracket

and thread the screw into the hole in the band saw, and

tighten securely.

3. Place a M8.4 flat washer onto a M8x1.25x20mm.

Insert the screw through the hole (H) Fig. 9, in the table

bracket and thread the screw into the hole in the band

saw, and tighten securely. Repeat this process for the

remaining hole (H) Fig. 9.

Fig. 9

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

No comments

Delta BS220LS Instruction Manual Page 8